2
Installing and Mounting
Arm Mount Applications
This section describes how to install the mount the arm mount configuration.
Install the Terminal in the Arm Mount Sled
1. If the end cap is installed on the sled, slide the lock down to release the
end cap.
2. Push up on the right side (the side with the lock) of end cap. Do not attempt to remove the end
cap without sliding the lock first!
3. Pull the end cap off the sled.
4. Make sure the USB door is closed. Rotate the door on the right side of the Dolphin 70e Black to close.
5. Press until the door is flush with the side of the terminal.
Note: If the door is not flush, it may be difficult to remove the terminal from the sled.
2 - 1