Brake Pads Wear; Fluid Filling - Honda 2010 CRF250R Service Manual

MAINTENANCE
FLUID FILLING
FRONT:
Remove the screws, reservoir cover and diaphragm , - - - - - - - -- - - - -- - - - - - ,
and fill the reservoir with DOT 4 brake fluid to the upper SCREWS UPPER LEVEL LINE
Do not bend the
dmphragm d(Jnng
instal/alion
level line.
Install the diaphragm and reservoir cover.
Install and tighten th e screws to the specified torque.
TORQUE: 1.0 N'm (0.1 kgf'm ,
O.7IbHt)
Check the entire system for leaks.
Inspect the brake hose and fittings for deterioration ,
cracks
Of
signs of leakage. Tighten any loose fittings.
Replace the hose and fittings as required.
REAR:
Remove the bolts, reservoir cover, plate and diaphragm
and fill the reservoir with DOT 4 brake fluid to the upper
level tine
Install the diaphragm , plate and cover.
Inslall and lighten the bolts to the specified torque.
TORQUE: 1.0 N'm (0.1 kgf'm , 0.7IbHt)
Check the entire system for leaks.
Inspect the brake hose and fillings for deterioration,
cracks or signs of leakage. Tighten any loose fillings.
Replace the hose and fittings as required.
BRAKE PADS WEAR
3-24
Inspect the pads. If either pad
IS
worn anywhere to a
thickness of 1.0 mm (0.04 in), both pads must be
replaced .
For brake pad replacement
Front (page 15-11)
- Rear (page 15-13)
Front:
LIMIT GROOVES
Rear:
LIMIT GROOVES
UPPER LEVEL LINE
1.0mm
(0.04 in)
~
n
I
LIMIT
~GROOVE
~~
1.0mm
(0.04 In)
I
- 0, __
LIMIT GROOVE