Swingarm Installation - Honda 2010 CRF250R Service Manual

REAR WHEEUSUSPENSION
14-40
Apply locking agenllo the rear side screw threads.
Inslall and tighten the screws with the washer and
collars to the speciflEld torque.
TORQUE : 4.2 N·m (0.4 kgf-m. 3.1 IbHt)
Install the chain guide slider (After '10: chain guide
sliders) to the chain guide, then install them to the
swingarm.
Install and lighten the bolts/nuts to the specified torque .
TORQUE: 12 N'm (1 .2 kgf'm , 9!bHt)
INSTALLATION
Apply a thin coat of grease to the swingarm pivot bolt
sliding surface.
Install the swingarm between the engine and frame.
install the swingarm pivot bolt from the right side
through the frame. swmgarm pivot and engine.
Installlhe washer and swingarm pivot nut.
Tighten the SWlngarm pivot
nul
to the specified torque.
TORQUE: 88 N'm (9.0 kgf'm , 65Ibf·ft )
I
CHAIN SLIDER
Dvm
SCREWS/COLLARS
BOLTS CHAIN GUIDE SLIDER