Remote Controller Description - Toyotomi HTN/HTG-09IV User Manual

Introduction for buttons on remote controller

Remote Controller Description

1
ON/OFF:
2
MODE
Each time you press this button, a mode is selected in a sequence that goes from AUTO, COOL,
DRY, FAN, and HEAT *, as the following:
After energization, AUTO mode is defaulted. In AUTO mode, the set temperature will not
be displayed on the LCD, and the unit will automatically select the suitable operation
mode in accordance with the room temperature to make indoor room comfortable.
3
Press this button to decrease set temperature. Hold it down for above 2 seconds to
rapidly decrease set temperature. In AUTO mode, set temperature is not adjustable.
+
4
Press this button to increase set temperature. Hold it down for above 2 seconds to
rapidly increase set temperature. In AUTO mode, set temperature is not adjustable.
FAN
5
This button is used for setting Fan Speed in the sequence that goes from AUTO,
6
Press button to start or stop up & down swing function.The remote controller defaults to
simple swing condition.
Press + button and
simple swing and static swing;
In static swing condition, pressing
changes as below:
B
, to then back to Auto.
Low speed
button at the same time at unit OFF to switch between
*Note: Only for models with heating function.
Auto
Medium speed
blinks for 2 seconds.
button, the swing angle of up & down louver
11
the unit.
High speed
GB