Supero SUPERSERVER 8046B-6RF User Manual page 84

S S
UPER ERVER 8046B-6RF/8046B-TRF User's Manual
Onboard SAS OPROM
Select Enabled to enable Onboard SAS Option ROM which will allow you to boot
the computer using a SAS device. The options are Enabled and Disabled.
Onboard LAN Option ROM Select
Select iSCSI to use iSCSI Option ROMs to boot the computer. Select PXE to use
PXE Option ROMs to boot the computer. The options are iSCSI and PXE.
LAN1 Option ROM/LAN2 Option ROM
Select Enabled to enable the onboard LAN1/LAN2 Option ROMs to boot the com-
puter using a network interface. The options are Enabled and Disabled.
Super IO Device Confi guration
Serial Port1 Address/IRQ, Serial Port2 Address/IRQ
This option specifi es the base I/O port address and the Interrupt Request address
of Serial Port 1 and Serial Port 2. Select Disabled to prevent the serial port from
accessing any system resources. When this option is set to Disabled, the serial port
physically becomes unavailable. Select 3F8/IRQ4 to allow the serial port to use 3F8
as its I/O port address and IRQ 4 for the interrupt address. The options for Serial
Port1 are Disabled, 3F8/IRQ4, 3E8/IRQ4, 2E8/IRQ3 and 2F8/IRQ3. The options for
Serial Port2 are Disabled, 2F8/IRQ3, 3E8/IRQ4, 3F8/IRQ4, and 2E8/IRQ3.
USB Confi guration
This feature allows the user to confi gure USB settings for the motherboard.
Legacy USB Support
Select Enabled to use Legacy USB devices. If this item is set to Auto, Legacy USB
support will be automatically enabled if a legacy USB device is installed on the
motherboard, and vise versa. The settings are Disabled, Enabled and Auto.
Port60h/64h Emulation
Select Enabled to enable 60h/64h emulation so that a USB keyboard can be sup-
ported by an operating system that is not compatible with USB devices. The options
are Enabled and Disabled.
USB 2.0 Controller Mode
This setting allows you to select USB 2.0 Controller mode. The options are Hi-Speed
(480 Mbps) and Full Speed (12 Mbps).
7-18