External Speaker; Voice Guide & Storage Unit - Kenwood TK-7360 Service Manual

13 10 7 4 1
14 11 8 5 2
15 12 9 6 3
KCT-60
KCT-18
2
Square plug
Ignition
line of the car
4. External Speaker (Option)
4-1. KES-3
The KES-3 is an external speaker for the 3.5-mm-diameter
speaker jack.
■ Connection procedure
1. Remove the speaker-jack cap on the rear of the trans-
ceiver.
2. Connect the KES-3 to the 3.5-mm-diameter speaker jack
on the rear of the transceiver.
4-2. KES-5
External speaker KES-5 can be installed for KCT-60.
■ Connection procedure
1. Remove the ACC. cap on the rear of the transceiver.
2. Connect the D-sub connector of the KCT-60 to the D-sub
15-pin terminal of the transceiver.
3. Insert the two crimp terminals of the KES-5 to pins 3 and
12 of the square plug.
4. Connect the square plug to the 15-pin connector of the
KCT-60.
INSTALLATION
Note:
You must set up using the KPG-135D(K) or KPG-135D(M).
Before the external speaker can be used, you must as-
sign one of the keys as "External Speaker", using the
KPG-135D(K) or KPG-135D(M).
Black/
White lead
5. Voice Guide & Storage Unit (VGS-1: Option)
5-1. Installing the VGS-1 unit in the transceiver
1. Remove the two screws on both sides of the transceiv-
er, then remove the cabinet and top packing from the
transceiver.
2. Remove the cover fi tted into the TX-RX unit connector
(CN700).
3. Attach two cushions to VGS-1
4. Insert the VGS-1 connector (CN1) into the TX-RX unit
connector (CN700).
Note: You must set up using the KPG-135D(K) or KPG-
135D(M).
Cushion
(G13-1994-04)
20x30x1.0mm
TX-RX PCB
TK-7360/7360H/7360H
13 10 7 4 1
14 11 8 5 2
15 12 9 6 3
KCT-60
12
3
Square plug
Black lead
VGS-1
Cover
CN700
V
( )
Cushion
(G13-1994-04)
20x30x12mm
Cushion
(G13-1974-04)
21x21x1.0mm
9