Power Supply - Panasonic PV-GS19 Operating Instructions Manual

Using the Remote Control
(PV-GS35 Only)
1
Direct the Remote Control at the Remote
Control Sensor of the Camcorder and
15
press an appropriate button.
15°
15°
15°
15°
• Distance from the Camcorder: Within
approximately 15 feet (5 meters)
• Angle: Within approximately 15° in the vertical
and horizontal directions from the central axis
• The above operating ranges are for indoor use.
Outdoors or under strong light, the Camcorder may
not operate properly even within the above ranges.
Selecting Remote Control Modes
When 2 Camcorders are used simultaneously, they
can be operated individually by selecting different
Remote Control Modes.
• If the Remote Control Mode of the Camcorder
and that of the Remote Control do not match with
each other, [REMOTE] will appear. When the
Remote Control is operated for the first time after
the Camcorder is turned on, [CHECK REMOTE
MODE] (p. 64) will appear and operation is
impossible. Set the same Remote Control Mode.
Setup on the Camcorder
Set [ REMOTE] on the [
the desired Remote Control Mode. (pp. 23, 24)
Setup on the Remote Control
2
[VCR1]:
Press the [Ι►] Button and [ ■ ] Button
simultaneously.
1
[VCR2]:
Press the [◄Ι] Button and [ ■ ] Button
simultaneously.
2
• When the battery in the Remote Control is replaced,
the mode is automatically reset to [VCR1] Mode.
Before Using
15
1
2
3
• Before connecting or disconnecting the
Before use, fully charge the Battery.
• We recommend using a Panasonic Battery.
• We cannot guarantee the quality of this Camcorder
1
2
SETUP] Sub-Menu to
1

Power Supply

Using the AC Adaptor
Connect the DC Cable to the Camcorder.
Connect the DC Cable to the AC Adaptor.
Connect the AC Cable to the AC Adaptor
and the AC Jack.
power supply, set the [OFF/ON] Switch
the Camcorder to [OFF] and make sure that
[POWER] Lamp is not lit. (p. 19)
32
Using the Battery
when batteries from other companies are used.
Attach the Battery to the AC Adaptor and
charge it.
Put the Battery on the Battery Mount by
aligning the mark, and then securely plug it
in.
• Since the Battery will not be charged when
the DC Cable is connected to the AC Adaptor,
disconnect it from the AC Adaptor.
• The [CHARGE] Lamp lights up, and charging
starts.
• When the [CHARGE] Lamp goes off, charging is
completed.
• When the battery is completely discharged, the
[CHARGE] Lamp blinks at first, but the battery is
charged normally. When the temperature of the
battery is too high or low, the [CHARGE] Lamp
blinks and the charging time becomes longer
than usual.
28 on
15