Stihl MS 210 Instruction Manual page 52

Versions without ElastoStart and
versions with Easy2Start
: Remove the remaining rope from
the rotor and grip.
: Thread the new starter rope through
the rotor and secure it with a simple
overhand knot.
: Thread the other end of the rope
through the guide bush (from inside)
and the underside of the starter grip
and secure it with one of the special
knots shown – do not wind the rope
onto the rotor.
MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
Installing the Rope Rotor
Standard versions
7
8
9
Versions with Easy2Start
7
8
9
9
: Coat rope rotor bearing bore with
resin-free oil.
: Slip rotor over the starter post – turn
it back and forth to engage anchor
loop of the rewind spring.
: Fit the pawl or pawls (9) in the rope
rotor.
English / USA
: Fit the washer (8) on the starter
post.
: Use a screwdriver or suitable pliers
to install the spring clip (7) on the
starter post and engage it on the
pawl's peg – the spring clip must
point clockwise as shown in the
illustration.
51