Motor Management; Adjusting The Carburetor - Stihl MS 210 Instruction Manual

English / USA
1
: Place fingers behind the air filter (1),
press thumbs against the housing
and swing filter in direction of rear
handle.
To avoid damaging the air filter,
remove and install it without tools.
: Blow out the filter with compressed
air from the clean air side.
If the filter fabric is caked with dirt or no
compressed air is available:
: Wash the filter in a clean, non-
flammable solution (e.g. warm
soapy water) and then dry.
: Reinstall the filter.
46

Motor Management

Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C

Adjusting the Carburetor

General Information
The carburetor comes from the factory
with a standard setting.
This setting provides an optimum fuel-air
mixture under most operating
conditions.
With this carburetor it is only possible to
correct the setting of the high speed
screw within fine limits.