Stihl - Stihl MS 210 Instruction Manual

If the engine is new, pull the starter
several times to prime the fuel system.
Standard versions:
: Pull the starter grip slowly with your
right hand until you feel it engage –
then give the grip a brisk strong pull
and push down the front handle at
the same time.
: Do not pull out the starter rope to its
full length – it might otherwise
break.
: Do not let the starter grip snap back
– guide it slowly and vertically into
the housing so that the starter rope
can rewind properly.
MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
Versions with Easy2Start:
Easy2Start stores the energy required to
start the chainsaw. Therefore, a delay of
a few seconds may occur between
cranking the engine and it actually
starting.
There are two ways of starting with the
Easy2Start:
: Pull the starter grip slowly and
steadily with your right hand
or:
Pull the starter grip in several short
strokes with your right hand, using
only a short length of rope for each
pull.
: Do not pull out the starter rope to its
full length – it might otherwise
break.
: Do not let the starter grip snap back
– guide it slowly and vertically into
the housing so that the starter rope
can rewind properly.
English / USA
0
5
3
4
When engine begins to fire:
: Move Master Control lever (3) to n
and continue cranking – as soon
as engine runs, immediately blip
the throttle trigger (4) –
the Master Control lever (3) will
move to the "run" position # (5) and
the engine settles down to idling
speed.
.
As the chain brake is still engaged,
the engine must be returned to
idling speed immediately – or the
engine and chain brake might
otherwise be damaged.
41