Operation - Morphy Richards Boxer wet & dry vacuum cleaner Instructions Manual

• To fit the Foam filter
1 Remove cartridge filter.
2 Slide foam filter fully down over the float
cage, located underneath the upper
body. E
3 Inspect your filter regularly. To clean the
filter, remove it from the float cage. If
required rinse the filter in cold, water.
E
• To fit the Cartridge filter
1 Position the filter and twist locking nut
clockwise F
F
2 To remove it turn the locking nut anti-
clockwise.
3 To clean it, brush the grooves with a soft
brush, ensuring you don't damage the
surface.
4 Inspect your filter regularly and if
damaged replace it immediately.
5 If used for wet pick-up wash the filter in
cold water and thoroughly dry before re-
fitting.
• To fit the Paper bag (if required)
1 To fit the paper bag, place it inside the
tank with the bag collar by the inlet. G
2 Bend the top of bag collar back at the
crease.
3 Push the bag collar over the inlet so that
the rubber seal holds the dust bag in
place. G
G
Ô

Operation

1 Unwind the lead fully and connect to the
mains.
2 Switch on using the on/off switch. ‹
Float shut-off wet use
When the tank is full of liquid the float
shut-off valve H automatically cuts off the
suction which is indicated by a higher
pitched noise from the motor. If this occurs:
H
1 Switch the unit OFF and disconnect from
the mains.
2 Raise hose to drain liquid back into the
tank.
3 Empty the tank.
IMPORTANT: Do not attempt to remove
the float as this is important for safe
performance. If the cleaner overturns during
use, switch the motor off, return to the
upright position and wait until the float falls
free.
5