8.
Place the thermal sensor on top of the hard drive in a position that does not cover the label (1)
and attach the thermal sensor to the top of the hard drive with the adhesive strip (2).
Figure 6-34
9.
Slide the cover on the carrier (1) and replace the screw on the rear of the carrier to secure the
cover in place (2).
Figure 6-35
10.
Slide the hard drive carrier into the enclosure on the computer and lock it with the key provided.
NOTE:
84
Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis
Replacing the Thermal Sensor
Replacing the Carrier Cover
The carrier must be locked for power to be supplied to the hard drive.