Brush Position Check; Adjustment And Pattern Check - Sony SAL50M28 Service Manual

4-6. BRUSH POSITION CHECK/ADJUSTMENT AND PATTERN CHECK
Note:
If dialog box of error code appears during the checking or adjustment, check the reason of error referring to page 4-20.

4-6-1. Brush Position Check

Equipment
• Personal Computer (PC)
• Camera DSLR-A100
• USB Cord With Connector
• Lens Adjustment Program
Note: Lens Adjustment Program is downloadable from the ESI homepage.
1. Preparations
1) Connect the checking lens to the camera.
2) Start the lens adjustment program "LensAdjustment.exe" referring to "4-1-2. Lens Adjustment Program".
2. Checking Method
1) Check that the "Type" is set to "1", and click the
Note:
Click the
2) Check that the "Type" is set to "1", and click the
3) Set the focus position to infinity end, then check that the OK (Green) indicator of "Position" lights as shown in Fig. 4-6-3.
If the NG (Red) indicator of "Position" lights, perform the "4-6-2. Brush Position Adjustment and Pattern Check".
[Exit]
4) Click the
[End]
5) Click the
6) Turn the POWER switch of the camera to OFF.
SAL50M28 (MACRO 2.8/50) (50mm F2.8 Macro)
Fig. 4-6-1
[End]
button to disconnect the USB connection, then lens adjustment program will terminate.
Fig. 4-6-2
Fig. 4-6-3
Fig. 4-6-4
button.
button to terminate the lens adjustment program.
[Connect]
button on the lens adjustment program.
[Focus]
button on the lens adjustment program.
4-17