4-7.
FOCUS BRUSH POSITION CHECK/ADJUSTMENT
Equipment (Only the specific equipment is listed)
• Adhesive bond (B-10)
4-7-1. Focus Brush Position Check
Use the Finished Inspection JIG II and confirm with "Search Focus-Adj" in the Lens Adjustment Program.
4-7-2. Focus Brush Position Adjustment
1. Preparation
1)
Set the lens to be checked to the condition as shown in Fig.4-7-1 by disassembling or assembling.
Fig.4-7-1
2)
Connect the F.ECD board to the main PCB assy as shown in figure.
F. ECD Flexible
Board
SAL55200-2 (DT 4-5.6/55-200 SAM) (DT 55-200mm F4-5.6 SAM)
Semi Barrel Assy
Main PCB Assy
Focus Brush
Fig.4-7-2
4-15