Zoom Brush Position Check/Adjustment And Pattern Check - Sony SAL75300 Service Manual

4-7.

ZOOM BRUSH POSITION CHECK/ADJUSTMENT AND PATTERN CHECK

Note:
If dialog box of error code appears during the checking or adjustment, check the reason of error referring to page 4-25.
4-7-1. Zoom Brush Position Check
Equipment
• Personal Computer (PC)
• Camera DSLR-A100
• USB Cord With Connector
• Lens Adjustment Program
Note:
Lens Adjustment Program is downloadable from the ESI homepage.
1. Preparations
1) Connect the checking lens to the camera.
2) Start the lens adjustment program "LensAdjustment.exe" referring to "4-1-2. Lens Adjustment Program".
2. Checking Method
[Connect]
1) Click the
Note:
Click the
[Zoom]
2) Click the
3) Set the zoom position to Wide end, and check that the OK (Green) indicator of "Position" lights as shown in Fig. 4-7-3.
Note:
Lens focus position setting is not required.
If the NG (Red) indicator of "Position" lights, perform the "4-7-2. Zoom Brush Position Adjustment and Pattern Check".
[Exit]
4) Click the
[End]
5) Click the
6) Turn the POWER switch of the camera to OFF.
SAL75300 (4.5-5.6/75-300) (75-300mm F4.5-5.6)
Fig. 4-7-1
button on the lens adjustment program.
[End]
button to disconnect the USB connection, then lens adjustment program will terminate.
Fig. 4-7-2
button on the lens adjustment program.
Fig. 4-7-3
Fig. 4-7-4
button.
button to terminate the lens adjustment program.
4-19