Table of Contents
Advertisement
Four Sided Faceplate Installation
The Faceplate Surround has 2 main parts, the rear panel
and the front panel. The Rear Panel has an master override
switch installed on the upper right corner. The Rear Panel
has to be installed first.
Found behind panel
Figure 48 Sec.7 Four Sided Faceplate Kit Contents
1). Remove the Lighting Instructions from the Control area
and leave on the floor in front of the unit.
Figure 49 Sec.7
2). Lift the Rear Faceplate up and over the Magnets located at
the top of the fireplace.
Figure 50 Sec.7
XG0508-
150204.1
Installation
Screws supplied
3) Temporarily, place the Electrical Cord through the hole in the
bottom right corner of the Rear Faceplate
Figure 51 Sec.4
4). Attach the Rear Faceplate to the Firebox using the screws
provided (13 locations)
Figure 52 Sec.4
5). Use self drilling screws to secure magnet as shown. The bottom
hole will need to drill a new hole in the process of securing.
Figure 53 Sec.4
I-Series Indoor Gas Fireplace
Page 27
Advertisement
Table of Contents
