Table of Contents
Advertisement
Brick Panel Installation
The 34FID-S must only be used with the Firebox Panels installed.
With the Fireplace Door removed, the panels can be easily installed.
1). Make sure all the Brick Panels are received in good order
Figure 1 Sec.9
2). Slide the side panel along the wall of the Firebox towards the
back of the Firebox. There is a retainer clip at the top and at the
bottom of the Firebox. These Firebox Panels will slide within them.
Leave enough room to slide the rear panel behind the side panel.
Figure 2 Sec.9
3). Place the Rear Brick Panel behind the Right Panel.
Figure 3 Sec.9
XG0508-
150204.1
Installation
4) . Install the Left Brick Panel along the left side of the Firebox.
Figure 4 Sec.9
5). Push top retainer in tighter if needed.
Figure 5 Sec.9 Retainer detail Top and Bottom
Figure 6 Sec.9 Completed brick installation
I-Series Indoor Gas Fireplace
Page 33
Advertisement
Table of Contents
