Starting Generator - Honeywell HW5600C Owner's Manual

Starting Generator

Starting Generator
WARNING
Thoroughly read and understand all information
provided in this Owner's Manual before operating
generator.
NOTICE
It is very important to maintain proper level of engine oil to
keep engine in good running condition.
• Check engine oil level prior to each use.
Starting generator with appliances connected can cause
permanent damage to appliances.
• NEVER start generator with electrical appliances
plugged in and turned on.
Place generator outside in a well-ventilated area.
1.
NOTICE
Keep the generator at a minimum of 6 feet (2 meters) from
any building, object, or wall.
2. Confirm the circuit breakers are set.
Set Tripped
FIGURE 16: Circuit Breaker Position
Test GFCI per instructions on page 25.
3.
4. Turn fuel shut-off valve to ON position.
FIGURE 17: Fuel Shut-off Valve — ON/OFF Position
5. Pull choke control to ON position.
ON
FIGURE 18: Choke Control
14 www.honeywellgenerators.com
Set Tripped
OFF
6. Press engine control switch to RUN position.
FIGURE 19: Engine Control Switch
Grip recoil starter handle and pull slowly until you feel
7.
slight resistance.
FIGURE 20: Recoil Starter Handle
NOTICE
Do not allow the recoil starter handle to snap back against
the engine. Return it gently to prevent damage to the starter.
Apply swift pulls to start the engine, carefully returning
8.
the recoil starter handle to the original position. This
may need to be repeated 2-3 times until the engine
starts.
NOTICE
If engine will not start, move the choke to the OFF posi-
tion to reduce fuel to the engine.
As engine warms up, and RPM stabilizes, gradually
9.
push choke control to OFF position.
Confirm the GFCI outlets are set (illuminated red).
10.
Set
FIGURE 21: GFCI Setting
HW5600C Portable Electrical Generator Owner's Manual
ENGINE
RUN
STOP
TEST
RESET