Pc Keyboard Wedge - Symbol LS 4000P Series Product Reference Manual

LS 4000P Series Product Reference Guide
2. Plug the 9-pin connector at the end of the scanner's coil cord into one end of the
battery box.
3. An output cable from the battery box connects the LS 4004P to the RS-232C input
device. Connect one end of this cable to the battery box and the other end to the
appropriate port on the host device (Figure 2-5).
Note: Coil cables that terminate in a 25-pin D-type connector have a power
receptacle on the side of the connector assembly.

PC Keyboard Wedge

To set up the LS 4006P standard PC keyboard wedge configuration:
1. Connect the keyboard connector on the PC Wedge cable to the host keyboard.
2. Connect the host connector on the PC Wedge cable to the keyboard interface port on
the host.
3. Connect the PC Wedge scanner connector to the scanner.
2-6
Portable
Terminal
Output Cable
Power
Supply
(Optional)
Figure 2-5. RS-232C Battery Operation
LS 4004P
Battery Box