Installation
Installation Procedure
Follow the procedure below to properly install.
Note
ˎ Before installing a module, make sure the power connector on the rear is unplugged, and the controller's POWER ON/OFF switch is set to
ˎ
OFF.
1
Align .the .convex .parts .of .the .bracket .() .with .the .concave .parts .of .the .module .() .and .attach .the .bracket .with .screws .
(M4×8/tightening .torque:1N•m)
2
Place .the .controller/module .in .the .rack .
3
Attach .the .controller/module .to .the .rack .with .the .(bracket) .screws .
Screws used for attaching to a rack are not included in the set. Please use screws attached with a rack.
Notes
ˎ EIA standard 19-inch rack is recommended.
ˎ
ˎ Always use a rack with support plate when you install on a rack. Use one plate per product.
ˎ
15