3.10.4
Adjustment of the Leading Edge Position
Note:
Note:
Check if the image adjustment for the equipment is performed properly before this adjustment of
the ADF/RADF. Also, the ADF/RADF position and height shall be adjusted properly.
[A] Checking
Check the image using the chart (original) with vertical and horizontal lines in the following procedure.
Simplex copying (ADF/RADF):
(1)
Place the chart provided as an original with its face up on the original tray of the ADF/RADF,
select [1 Sided -> 1 Sided] and press the [START] button.
(2)
Superimpose the chart on the copy and check the leading edge E of the chart and F of the copy.
Duplex copying (RADF):
(1)
Place the chart provided as an original with its face up on the original tray of the RADF, select
[2 Sided -> 2 Sided] and press the [START] button.
(2)
Superimpose the chart on the copy and check the leading edge E of the chart and F of the copy.
Fig. 3-60 Chart (Original)
© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved
E
3 - 57
F
Fig. 3-61 Copy
e-STUDIO165/167/205/207/237
ADJUSTMENT
3