Installation With The Holder; Installation Using The Screw; Holes On The Side Of This Product; Installing The Microphone - Pioneer AVH-X8650BT Owner's Manual

Dvd rds av receiver
Hide thumbs Also See for AVH-X8650BT:
Table of Contents

Advertisement

2 Insert the supplied extraction keys
into both sides of the unit until
they click into place.
3 Pull the unit out of the holder.
1
1 Extraction key

■ Installation with the holder

1 Install the holder into the
dashboard.
2 Secure the mounting sleeve by
using a screwdriver to bend the
metal tabs (90°) into place.
1
2
1 Dashboard
2 Holder
3 Install this product into the holder.
1
1 Dashboard
4 Attach the trim ring.
1
2
1 Trim ring
2 Groove
Attach the trim ring with the side with a
groove facing downward.

■ Installation using the screw

holes on the side of this product

Fastening this product to the fac-
tory radio-mounting bracket.
Position this product so that its screw holes
are aligned with the screw holes of the
bracket, and tighten the screws at three
locations on each side.
If the pawl interferes with installation,
you may bend it down out of the way.
1
4
3
2
1 Factory radio-mounting bracket
2 Dashboard or console
3 Frame
In some types of vehicles, discrepancy
may occur between the unit and the
dashboard. If this happens, use the
supplied frame to fill the gap.
4 Truss head screw
Be sure to use the screws supplied with
this product.

Installing the microphone

Install the microphone in a place where
its direction and distance from the driver
make it easiest to pick up the driver's
voice.
Be sure to turn off (ACC OFF) the product
before connecting the microphone.

■ Mounting on the sun visor

1 Fit the microphone lead into the
groove.
1
2
1 Microphone lead
2 Groove
2 Attach the microphone clip to the
sun visor.
1
2
1 Microphone clip
2 Clamps
Use separately sold clamps to secure the
lead where necessary inside the vehicle.
Install the microphone on the sun visor
when it is in the up position. It cannot rec-
ognize the driver's voice if the sun visor is in
the down position.
■ Installation on the steering
column
1 Detach the microphone base from
the microphone clip by sliding the
microphone base while pressing
the tab.
1
2
4
3
1 Microphone
2 Tab
3 Microphone base
Chapter
28
63
En

Advertisement

Table of Contents
loading

Table of Contents