Precor 9.23 Service Manual page 43

9. Remove the five screws that fasten the upper PCA to the console and remove the upper
PCA from the console.
10. Set the upper PCA in its mounting position in the replacement console and fasten it with the
hardware removed in step 9. Connect the keypad connector to the JK5 connector of the
upper PCA.
11. When furnished mount the heart rate receiver removed in step 8 with the hardware removed
in step 8. Connect the heart rate receiver connector to the JK2 connector on the upper PCA.
12. Snap the safety switch, removed in step 6, into its mounting on the console. Connect the
safety switch connector to the SW1 connector on the upper PCA.
13. Set the safety switch cover in its mounting position and fasten it with the hardware removed
in step 6.
14. Set the console in its mounting position on the targa uprights and fasten it with the hardware
removed in step 5.
15. Connect the interconnect cable to the JK1 connector on the upper PCA. dress the
interconnect cable into place and fasten it with cable ties.
16. Set the backplate in its mounting position and fasten it with the hardware removed in step 3.
17. Check treadmill operation per Section 3.
9.23, 9.27 Treadmill
Page 43