Procedure 6.7 - Replacing The On/Off Switch - Precor 9.23 Service Manual

Procedure 6.7 - Replacing the On/Off Switch

1. Set the treadmill's on/off switch in the "off" position and remove the treadmill's power cord
from the AC outlet.
2. Remove the treadmill's hood.
3. Remove the red, re-black, white and black wires from the on/off switch.
4. Depress the four clips on the on/off switch (two on the top and two on the bottom) and push
the on/off switch out of the front of its mounting plate. Refer to Diagram 6.6.
Diagram 6.6 - On/Off Switch
Clip
5. Orient the on/off switch so that the "off" position is on top, refer to Diagram 6.7. Insert the
replacement on/off switch into its mounting hole from the front of the mounting plate and
press it into the mounting plate until it snaps into place.
Diagram 6.7 - On/Off Switch Orientation
On
9.23, 9.27 Treadmill
Clip
Off
Page 37