RX-V371/HTR-3064
22. SOFT SWITCH
When the following parts are replaced, the model name and the destination MUST be written to the back-up IC
(EEPROM: IC222 on DIGITAL P.C.B.) to have proper operation.
• DIGITAL P.C.B.
• EEPROM: IC222 on DIGITAL P.C.B.
Note) When the DIGITAL P.C.B. is replaced, the firmware must be updated to the latest version.
(See "UPDATING FIRMWARE")
* The model name and destination set in this menu are preserved even after this unit is initialized.
22-1. SWITCH MODE
Press the "STRAIGHT" key to select the "22. SW: MODEL". This unit is in the mode where the model name and
the destination can be written.
22. SW: PCB:
22. SW: MODEL: Model name and destination can be written.
22-2. MODEL
Press the "STRAIGHT" key to select the model name, "V371" (RX-V371) or "H3064" (HTR-3064). Selected model
name is written automatically.
22-3. DESTINATION
Press the "STRAIGHT" key repeatedly to select the destination. Selected destination is written automatically.
Press the "STRAIGHT"
2 2 . D E S T : U
2 2 . D E S T : K
44
Model name and destination can not be written.
* When selecting "22. SW: MODEL", be sure to switch back to "22. SW: PCB" after correct model
name and destination is set.
2 2 . S W
: P C B
Press the "STRAIGHT" key
2 2 . M O D E L : V 3 7 1
Press the "STRAIGHT" key
2 2 . D E S T : C
2 2 . D E S T : A
2 2 . S W
: M O D E L
2 2 . M O D E L : H 3 0 6 4
2 2 . D E S T : R
R: R, S models
2 2 . D E S T : G
G: B, G, F models
2 2 . D E S T : T
2 2 . D E S T : L