Table of Contents
Advertisement
Getting started
Battery installation & charging
After battery installation, place each handset in the telephone base or a charger
and allow it to charge for 16 hours before use. You can keep the battery packs
charged by returning the handsets to the telephone base or chargers after each
use. When the battery is fully depleted, a recharge takes about 16 hours. The
average talk time on a fully charged battery is about eight hours depending on
environmental conditions, standby time is approximately four days.
Press in and downward on
the tab to open the battery
compartment cover.
Plug power adapter into the jack
on the underside of charger as
shown, then plug into an electri-
cal outlet.
Caution: Use only supplied rechargeable battery or replacement battery pack (part number 80-5848-
00-00).
NOTE: Use only the power adapter supplied with this product. If you need a replacement, call 1 (800)
222-3111. In Canada, call 1 (866) 288-4268. Be sure to use an electrical outlet not controlled by a wall switch.
Plug the battery
pack connector
into handset.
Place handset in base or
charger to charge for 16 hours
before first use.
Place the battery
pack and wires in
Slide battery compart-
the compartment.
ment cover up until it
clicks closed.
LOW BATTERY
Low battery indicator
Return handset to base
or charger to recharge
when this symbol flash-
es. (Handset will beep
when battery is low.)
Advertisement
Table of Contents
