AT&T E5943B User Manual page 54

Appendix
Troubleshooting
Common cure
for electronic
equipment.
Incomplete
messages.
Difficulty hear-
ing messages.
System does
not answer
after correct
number of
rings.
"CL" flashes
in message
window.
• If the phone does not seem to be responding normally, try
putting the cordless handset in its base. If it does not seem to
respond, do the following (in the order listed):
• Disconnect the power to the base.
• Disconnect the cordless handset battery, and spare battery, if
applicable.
• Wait a few minutes.
• Connect power to the base.
• Re-install the battery pack, and place the cordless handset into
the base.
• Wait for the cordless handset to re-establish its connection with
the base. To be safe, allow up to one minute for this to take
place.
• If a caller leaves a very long message, part of it may be lost
when the system disconnects the call after four minutes.
• If the caller pauses for more than seven seconds, the system
stops recording and disconnects the call.
• If the system's memory becomes full during a message, the sys-
tem stops recording and disconnects the call.
• If the caller's voice is very soft, the system may stop recording
and disconnects the call.
^
•. Press.VOLUME.
• Make sure that the answering system is on (see page 0).
• If Toll Saver is activated, the number of rings changes to two
when you have new messages waiting (see page ).
• In some cases, the system may be affected by the ringing sys-
tem used by the local telephone company.
• If the memory is full or the system is off, the system will answer
after 0 rings.
• You need to reset the answering system clock (see page ).
.to increase speaker volume.
0