Optional Fan Installation - Napoleon GD36NTR Installation And Operation Instructions Manual

OPTIONAL FAN INSTALLATION

ELECTRICAL INSTALLATION TO BE DONE BY A QUALI-
FIED INSTALLER and must be connected and grounded
in accordance with local codes. In the absence of local
codes, use the current CSA C22.1 C
in Canada or the ANSI/NFPA 70
United States.
GD36 THERMOSTATIC SENSOR CONTROL
With the thermostatic sensor option, the fan, when turned
on, becomes thermally activated, and will automatically run
approximately 15-30 minutes after the fireplace has been
lit and for approximately 30-45 minutes after the fireplace
has been turned off.
Use of the fan increases the output of heat.
Unplug the power cord from the receptacle. Connect all
wires as shown.
FIGURE 56
ANADIAN ELECTRICAL CODE
in the
NATIONAL ELECTRICAL CODE
FIGURE 54
To safely install the fan, turn off the electricity first.
If the fireplace was not previously equipped with a fan:
route a grounded 2-wire, 60hz power cable to the junction
box. At this point, it must be strain
relieved and insulated.
The wire harness provided in
this kit is a universal harness.
When installed, ensure that any
excess wire is contained, pre-
venting it from making contact
with moving or hot objects.
To ease installation of the fan,
remove the hinge screen and valve control door (lower lou-
vres) from the base of the fireplace.
Position the vibration reducing pad into the clip and onto
the threaded stud at the other end, piercing a hole into the
pad. The fan assembly must be able to be positioned en-
tirely onto the pad.
Slide the fan assembly past the controls and into the clip.
Secure using the lock washer and nut provided.
Plug the harness cord into the receptacle.
This optional kit is meant to be used only in conjunction
with the GD65 Fan Kit, shown above, which may be or-
dered from your Wolf Steel / Napoleon dealer.
Attach and secure the sensor assembly bracket to the se-
curing stud located next to the receptacle/junction box at
the bottom left of the unit using the lock washer and wing
nut. Ensure that the thermodisc touches the firebox wall.
Plug the power cord back into the receptacle.
When installed, ensure that any excess wire is contained,
preventing it from making contact with moving or hot objects.
FIGURE 57
27
FIGURE 55
W415-0210 / G / 12.10.04