Ford Mondeo Owner's Handbook Manual page 232

CAUTIONS
Do not bend or damage the valves
when you are inflating the tyres.
Have tyres installed by properly
trained technicians.
The system monitors the pressure in the
tyres using sensors located on the wheels
and a receiver located in your vehicle.
When the system detects low pressure
in the tyres, a warning message is
displayed in the information display. See
Information messages (page 91).
If a low pressure warning message is
displayed in the information display, check
the tyre pressures as soon as possible
and inflate them to the recommended
pressure. See Technical
specifications (page 231). If this
happens frequently, have the cause
determined and rectified as soon as
possible.
Checking the tyre pressures
Note: If the tyre pressures are greater
than or equal to 3.3 bar (48 lbf/in²), you
will see the + symbol below the pressure
value. The system only measures
pressure up to 3.3 bar (48 lbf/in²). The +
symbol indicates that the tyre pressures
may be higher.
Note: Type 3 instrument clusters have a
slightly different menu structure. Select
Settings first to access Information.
1. Press the right arrow button on the
steering wheel to enter the main
menu.
2. Highlight Information with the up
and down buttons and press the right
arrow button.
Wheels and tyres
3. Highlight Tyre Pressures with the
4. Highlight the desired setting and press
5. Press the left arrow button to exit the
Setting the vehicle load
Note: Type 3 instrument clusters have a
slightly different menu structure. Select
Settings first to access Setup.
Correct tyre pressure settings depend on
vehicle load. See Technical
specifications (page 231). The system
can only detect low pressure if you have
entered the current vehicle load.
1. Press the right arrow button on the
2. Highlight Setup with the up and down
3. Highlight Tyre Pressures with the
4. Highlight the desired setting and press
5. Press the left arrow button to exit the
230
up and down buttons and press the
right arrow button.
the OK button to confirm the setting.
menu. Hold the left arrow button
pressed to return to the trip computer
display.
steering wheel to enter the main
menu.
buttons and press the right arrow
button.
up and down buttons and press the
right arrow button.
the OK button to confirm the setting.
menu. Hold the left arrow button
pressed to return to the trip computer
display.