Ford Mondeo Owner's Handbook Manual page 112

Note: The programming procedure may
be repeated as often as is required. The
oldest programmed transmitter will be
deleted each time.
1. Install the battery in the new
transmitter.
2. Turn off the power to the receiver by
removing fuse F32 from the engine
compartment fuse box. See Fuse
specification chart (page 186).
3. Wait for at least 5 seconds.
4. Reconnect power to the receiver by
replacing the fuse, and press the OFF
button on the new transmitter within
5 seconds until the LED light turns off.
5. The new transmitter is now
programmed.
Fuel operated heater
(depending on country)
WARNING
The fuel operated heater must not
be operated at filling stations, near
sources of combustible vapours or
dust or in enclosed spaces.
The fuel operated heater aids in warming
the engine and the vehicle interior on
vehicles with a diesel engine. It is switched
on or off automatically depending on the
outside air temperature and the coolant
temperature, unless you have deactivated
it. When the fuel operated heater is
operating, Aux. Heater on is displayed
in the information display. See
Information displays (page 78).
To deactivate the fuel operated heater:
Climate control
E70499
1. Press the right arrow button on the
2. Highlight Setup with the up and down
3. Highlight Aux. Heater and press the
4. Press the left arrow button to exit the
Diesel auxiliary heater
(depending on country)
The diesel auxiliary heater (PTC electrical
heater) aids in warming the vehicle interior
on vehicles with a diesel engine. It is
switched on or off automatically
depending on the outside air temperature,
the coolant temperature and the
alternator load.
110
steering wheel to enter the main
menu.
arrow buttons and press the right
arrow button.
OK button to toggle the heater on and
off. A cross appears in the box when
the heater is activated.
menu. Hold the left arrow button
pressed to return to the trip computer
display.