Ford Mondeo Owner's Handbook Manual page 111

Remote start in combination
with direct start or timer
E114360
Remote start is integrated with normal
heater control. Parking heaters started
with direct start or timer functions can be
switched off with the remote control
transmitter and vice versa.
Feedback during starting and
switching off
The LED on the transmitter illuminates
green for about two seconds. This
indicates the signal has been received by
the vehicle and the heater has started.
The LED on the transmitter illuminates red
for about two seconds. This indicates the
signal has been received by the vehicle
and the heater has switched off.
The LED on the transmitter flashes green
or red for about two seconds. This
indicates the signal was not transmitted
correctly. Repeat the transmission.
The LED on the transmitter illuminates
orange for about two seconds before
showing green or red. This indicates the
transmitter batteries are weak and should
be changed.
The LED on the transmitter flashes orange
for about 5 seconds. This indicates that
the signal was not transmitted. The
transmitter batteries are discharged and
should be changed as soon as possible.
Climate control
Changing the remote control
battery
Make sure that you dispose of old
batteries in an environmentally friendly
way. Seek advice from your local authority
regarding recycling.
E114361
1. Insert a screwdriver or other suitable
2. Carefully prise out the battery.
3. Install a new battery (3.3V type
4. Re-assemble the remote control.
Programming the transmitter
Further transmitters may be used with the
remote system, please consult your
dealer. Up to a maximum of 3 separate
remote controls may be added. When
adding extra transmitters these must be
programmed separately.
Note: The heater must be switched off
during programming.
109
1
tool into the slot on the back of the
remote control, and unscrew the
compartment cover.
CAUTION
Do not touch the battery contacts or
the printed circuit board with the
screwdriver.
CR1-3N) with the + facing upwards.
2