Ford Mondeo Owner's Handbook Manual page 110

5. To set the time at which the vehicle
should be warmed up, highlight the
time at the top of the display and
press the right arrow button.
6. Press the OK button and the hours
flash. Use the up and down arrow
buttons to adjust the individual settings
and the left and right arrow buttons to
move to the next or previous setting.
7. When you have finished, press the OK
button again to confirm the selection.
Parkheater
Program 1
07:55
01:12:2006
OK = change
E74469
You can use the function Program 2 to
set a second cycle, for example different
times on different days or twice on the
same day. The programming procedure
is the same as for the function Program
1.
Programming the function
One-Time
1. Highlight One-Time and press the
right arrow button.
2. Press the OK button and the hours
flash. Use the up and down arrow
buttons to adjust the individual settings
and the left and right arrow buttons to
move to the next or previous setting.
3. When you have finished, press the OK
button again to confirm the selection.
Climate control
Active now
Highlight Active now and press the OK
button. A cross appears in the box next
to the function to show that the heater is
activated.
To deactivate the heater, highlight Active
now and press the OK button again.
Remote starting
The parking heater may be started and
switched off from a distance of up to 500
metres (1640 feet) using the supplied
remote control transmitter. This range will
vary depending upon local conditions and
terrain, as well as battery condition. The
remote control transmitter will indicate
whether or not the signal has been
received. The parking heater will operate
for a maximum of 30 minutes.
Note: The heater will operate, depending
on the ambient temperature, for between
10 and 30 minutes. The interior will cool
down after the heating period has
elapsed, therefore a remote start more
than 30 minutes before driving is not
recommended.
Note: The remote control may not
always receive confirmation of a
successful remote command at extended
operating ranges.
Starting
Hold the transmitter with the antenna
upwards and press the ON button for at
least two seconds. The LED on the
transmitter lights up green to confirm the
signal has been received.
Switching off
Hold the transmitter with the antenna
upwards and press the OFF button for at
least two seconds. The LED on the
transmitter lights up red to confirm the
signal has been received.
108