Operation: Ice Or Water Vending - Scotsman MDT6N90 Installation And User Manual

MDT6N90 User Manual

OPERATION: Ice or Water Vending

When the ice dispensing sensor detects a
container in front of it, the control board connects
an electrical circuit to the ice chute door solenoid
causing the ice chute door to open. At the same
time power is connected to the agitator drive
motor.
Dispensing takes place when the agitator sweeps
the ice through the ice dispensing chute: ice will
continue to discharge out this chute as long as the
agitator is turning. It stops when the agitator stops
and the ice chute door
closes.
·
If the user does not
remove the container, ice
will be dispensed for 60
seconds and then stop.
If the container is in front of
the water sensor on the left
side, the inlet water valve
will open and water will flow
into the container.
·
If the user does not
remove the container
water will be dispensed
for 90 seconds and then
stop.
STORAGE BIN
AGITATOR
AGITATOR
DRIVE MOTOR
TOUCH FREE
SENSOR
SINK
November 2008
Page 8
ICE DISCHARGE CHUTE
DOOR
SOLENOID
ICE CHUTE
DOOR
ICE CHUTE