Signature Command System Operation - MHSC DIRECT VENT MLDV500 Installation And Operating Instructions Manual

MLDV Series Gas Fireplace
FEATURES
Command Center
•
Easy Access Function Operation and System Configuration
•
Operation Confirmation/Fault Diagnostic Indications (LED/
Buzzer)
•
ON/OFF/HI/Med/Low Operation
•
Optional Wall Mounting
Control Board
•
Electronic Ignition
•
Pilot Lockout safety feature
•
Electric Power Regeneration from Thermopile to save battery
•
6-hour Automatic Shut Down Option
•
Convenient NG/LP Gas Type Conversion
•
Standing Pilot/Intermittent pilot Conversion
•
Previous settings Restoration Ability (Memory Off)
•
Uninterrupted Operation During Power Outage (Automatic
Battery Backup)
•
ON/OFF RF Remote Receiver
•
Optional Transmitter Learn Capability
AC Module Board (Optional, requires TSFSC Remote)
•
Easy Snap-on Design
•
Embedded Compact 10 VAC Adapter with Auto Battery Back
up Feature
•
Remote Controlled 3-step Blower, Lighting, and On/Off Auxil-
iary AC Outputs
Transmitter (Optional)
Three Flame Height Settings
Low battery Indication for Transmitter
Child Proof Lock-out
LCD Backlight
Security Codes 16
Countdown 6 hr Timer
Standard Thermostatic Control Mode
Smart Mode Thermostat
Three Brightness Settings for Lights
Three Speed Control for Blower
On/Off Auxiliary
Programmable Timer to turn blower on and off
BATTERY INSTALLATION
The Command Center uses four (4) "AA" batteries as back up for power outages. The system can operate for ap-
proximately six (6) months on battery power.
To Install Batteries (not included):
1. Press down the battery door tabs and pull out to remove battery door.
. Install the batteries as indicated on Command Center.
3. Close battery door by snapping in place.
4. When the four (4) batteries are installed the system will operate without power.
5. The batteries should be replaced when the LED indicates low battery or at least once a year.
44
SIGNATURE COMMAND SYSTEM OPERATION INSTRUCTIONS
(Auto Flame & Blower Modulation)
NG/LP
Conversion
Control Board
6 V A/C
Adapter
Master Switch
Command
Center
Figure 62 -
Signature Command System Components
TSFSC TSTSC
X X
X X
X X
X X
X X
X X
X X
X X
X --
X --
X --
X --
To Thermopile
RF Receiver
ON/OFF
To Sensor
To Stepper Motor
To Valve
OFF
LED
ON
Battery Door
FP1917
Signature components
TSMSC RTSC
8/08
X X
X X
X X
X X
X X
X --
-- X
-- --
-- --
-- --
-- --
-- --
To Sparker
To Command Center
RMSC
X
X
X
X
X
--
--
--
--
--
--
--
75D0004