Table of Contents
Advertisement
B-Vent Specialty Gas Fireplaces
FEATURES
Command Center
•
Easy Access Function Operation and System Configuration
•
Operation Confirmation/Fault Diagnostic Indications (LED/
Buzzer)
•
ON/OFF/HI/Med/Low Operation
•
Optional Wall Mounting
Control Board
•
Electronic Ignition
•
Pilot Lockout safety feature
•
Electric Power Regeneration from Thermopile to save bat-
tery
•
6-hour Automatic Shut Down Option
•
Convenient NG/LP Gas Type Conversion
•
Standing Pilot/Intermittent pilot Conversion
•
Previous settings Restoration Ability (Memory Off)
•
Uninterrupted Operation During Power Outage (Automatic
Battery Backup)
•
ON/OFF RF Remote Receiver
•
Optional Transmitter Learn Capability
Transmitter (Optional)
Three Flame Height Settings
Low battery Indication for Transmitter
Child Proof Lock-out
LCD Backlight
Security Codes 16
Countdown 6 hr Timer
BATTERY INSTALLATION
The Command Center uses four (4) "AA" batteries as back up for power outages. The system can operate for approxi-
mately six (6) months on battery power.
To Install Batteries (not included):
1. Press down the battery door tabs and pull out to remove battery door.
2. Install the batteries as indicated on Command Center.
3. Close battery door by snapping in place.
4. When the four (4) batteries are installed the system will operate without power.
5. The batteries should be replaced when the LED indicates low battery or at least once a year.
24
SIGNATURE COMMAND SYSTEM OPERATION INSTRUCTIONS
TSMSC
X
X
X
X
X
X
RF Receiver
ON/OFF
NG/LP
Conversion
Control
Board
OFF
LED
ON
Master Switch
Command
Center
Battery Door
Figure 18 -
Signature Command System Components
FP1917
RMSC
Signature components
X
X
8/08
X
X
X
--
To Thermopile
To Sensor
To Sparker
To Command Center
To Stepper Motor
To Valve
20301938
Advertisement
Table of Contents
