Door Cover Protect Removal; Door Lock Assembly; Door Lock Assembly Strip Circuit; Door Lock Assembly Tests - GE GFWS2500 Technical Service Manual

Door Cover Protect Removal

1. Remove the door assembly. (See Door Assembly
Removal)
2. Remove the door frame. (See Door Frame
Removal)
3. Lift the door glass to remove.
4. Unsnap the twelve snaps to remove the door
cover protect.
Clip

Door Lock Assembly

Door Switch
Solenoid Operating Voltage: 120 VAC
Solenoid Resistance: 50 Ω
Location: See Door Lock Assembly Location on
page 34.
The door lock assembly mechanically locks and
unlocks the door, and gives door switch and door
lock status to the IMC board. Each time the solenoid
is operated the position of the mechanical lock and
the door lock switch changes position.
The door can be manually unlocked by press-
ing down on the manual unlock lever (See Image
Above).
Clip
Clip
Pin 2

Door Lock Assembly Strip Circuit

IMC J701-6
IMC J101-2
To Neutral
Locking and Unlocking
Neutral is switched to the door lock assembly by
the door switch. L1 is pulsed to the other side of the
solenoid from IMC J701-5 when the door is locked
or unlocked.
Door Position Detection
When the door switch is closed, neutral is present at
IMC J701-5 indicating that the door is closed. When
the door switch is open, neutral is not present
at IMC J701-5 indicating that the door is open.
Lock Position Sensing
When the door is locked the lock switch will be
closed, causing neutral to be present at IMC J701-1
indicating that the door is locked. When the door is
not locked the lock switch will be open and neutral
will not be present at IMC J701-1 indicating the door
is not locked.

Door Lock Assembly Tests

1. Enter Service Mode.
2. Run Test 14.
a. Press the Start button to begin the test.
b. The door will lock and the LC will be displayed
in the display.
c. Pressing the Start button again will unlock the
door and UL will be displayed in the display.

Door Lock Assembly Diagnostics

Solenoid Not Operating
1. Disconnect power to unit.
2. Disconnect IMC J701. While holding the door
switch in, check resistance between IMC J701-5
and IMC J101-6.
a. If resistance is greater than 15Ω, check wiring
and replace door lock assembly if wiring is ok.
b. If resistance is ~15Ω replace IMC board.
41
Diverter Motor
D