GRAUPNER POLARON PRO Operating Manual page 67

NUMBER OF CELLS CHECKING
After connecting the balance board, the charger can check the number
of cells. If the confirmed number of cells is not correct, tap the ESC
button to return to the previous page. Re-check the parameters.
With the correct number of cells, the next page will be accessed
automatically. To initiate the process without a balance board, the cell
can be activated and the number of cells programmed into the cell.
Tapping the Enter
This page (left) shows the cycle process with the parameters and graph.
Both the voltage and current values will increase to the preset
parameters. The preset current may be limited by the charge/discharge
capacity and ithe nput voltage setup.
The max charging process operates at 500W with a max discharging
process at 60W by CH 1. And the max charging process operates at 30W
with a max discharging process at 5W by CH 2.
CYCLE OPERATING SCREEN
THE OPERATING INDICATOR BLINKS AT THE TOP
THE NUMBER OF OPERATING CYCLES IS SHOWN
TAP THE GRAPH TO DISPLAY THE OPERATING DATA
Tap the part in the red circle (left) to display the set current window.
The charge/discharge current parameters used during the operations
can then be entered.
Tap the „X" button to close the set current window.
These parameters are used by the charger during the operation and are
not stored in the memory.
button will cause the charger
to immediately initiate the char ging
process.
67