ECS P4IBMS Instruction Manual page 31

1. Install the FDD into the drive cage in your Micro ATX
system case.
2. Plug the FDD cable into FDD1 (A):
Note: The ribbon cable connectors are keyed so that they
can only be installed correctly on the device connec-
tor. If the connector is not keyed, make sure that you
match the pin-1 side of the cable connector with the
pin-1 side of the device connector. Each connector
has the pin-1 side clearly marked. The pin-1 side of
each ribbon cable is always marked with a colored
stripe on the cable.
3. Plug the correct connector on the FDD cable for the
5.25-inch or 3.5-inch drive into the FDD connector (B).
4. Plug a power cable from the case power supply into
the power connector on the FDD (C).
When you first start up your system, go immediately to the
Setup Utility to configure the floppy diskette drives that you
have installed. See Standard CMOS Features on page 39 for
more information.
25