Programmable Function Keys - Icom iC-F3161DT Instruction Manual

2
PANEL DESCRIPTION
y BELL INDICATOR
Appears/blinks when the matched signal is received,
according to the pre-programming.
u CALL CODE MEMORY INDICATOR
Appears when the call code memory is selected.
i BATTERY INDICATOR
Appears or blinks when the battery power decreases to a
specified level.
Indication
Battery level
blinks when the battery is over charged.
blinks when the battery is exhausted.
o ALPHANUMERIC DISPLAY
➥ Displays an operating channel number, channel name,
Set mode contents, DTMF code, etc.
➥ The indication mode can be selected from 1 line or 2
lines. Ask your dealer for details.
• In this instruction manual, the LCD illustration is described
using the 2 lines indication mode.
!0 KEY INDICATOR
Indicate the programmed function of the front panel keys
([P0], [P1], [P2] and [P3]).
5
Charging
Full Middle
required

■ Programmable function keys

The following functions can be assigned to [EMR], [Side1],
[Side2], [Side3], [P0], [P1], [P2] and [P3] programmable
function keys.
Consult your Icom dealer or system operator for details
concerning your transceivers
If the programmable function names are bracketed in the
following explanations, the specific key is used to activate the
function depends on the programming.
No battery CH UP AND DOWN KEYS "UP" "DOWN"
➥ Push to select an operating channel. When [Rotary
selector] selects "operating channel," this key is not
available.
➥ Push to select a transmit code channel after pushing
[TX Code CH Select].
➥ Push to select a DTMF channel after pushing [DTMF
Autodial].
➥ Push to select a scan group after pushing and holding
[Scan].
➥ Push to select the desired application type, individual/
talkgroup ID, TX status message and SDM (Short Data
Message) after pushing [Digital Button].
programming.