Scrolling The Theaterwide ® Picture; (Theaterwide 2 And 3 Only); Using The Auto Aspect Ratio Feature - Toshiba 32HL95 Owner's Manual

Scrolling the TheaterWide

(TheaterWide 2 and 3 only)

You can set separate scroll settings for TheaterWide 2 and
TheaterWide 3 modes for each for each input.
To set the scroll settings:
1. Press MENU and open the Video menu.
2. Highlight Theater Settings and press ENTER.
Video
Picture Settings
Advanced Picture Settings
Theater Settings
Navigate Select CH RTN Back EXIT
3. Select which input you want to set the picture size and
scroll setting for.
4. In the Picture Size field, select either TheaterWide 2 or
TheaterWide 3 (you cannot scroll in any other mode).
5. Press z to highlight the Picture Scroll field.
6. Press x • to scroll the picture up and down as needed,
from –10 to +20.
Theater Settings
Picture Size
Picture Scroll 0
Cinema Mode
Auto Aspect Ratio
Reset
7. To save the new settings, highlight Done and press
ENTER. To revert back to the factory defaults, highlight
Reset and press ENTER.
Chapter 8: Using the TV's features
®
picture
Exit
TheaterWide 3
Film
On
Done
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.

Using the auto aspect ratio feature

When the Auto Aspect feature is set to On and one of the
following input sources is received, the picture size is
automatically selected (as described in the table below):
• A 480i signal from the VIDEO 1, VIDEO 2, ColorStream
HD-1, or ColorStream HD-2 input.
• A 480i or 480p signal from the HDMI input.
Aspect ratio
of signal source
4:3 normal
4:3 letter box
16:9 full
Not defined
(no ID-1 data or )
HDMI aspect data)
Note:
• The Auto Aspect feature is not applicable to antenna or Cable input
sources.
• The Auto Aspect feature is not available when the FREEZE mode is
active, or the TV Guide On Screen™ system is open.
To turn on the Auto Aspect feature:
1. Press MENU and open the Video menu.
2. Highlight Theater Settings and press ENTER.
Video
Picture Settings
Advanced Picture Settings
Theater Settings
Navigate Select CH RTN Back EXIT
3. In the Auto Aspect Ratio field, select On.
4. To save the new settings, highlight Done and press
ENTER. To revert back to the factory defaults, highlight
Reset and press ENTER.
Theater Settings
Picture Size
Picture Scroll -1
Cinema Mode
Auto Aspect Ratio
Reset
To turn off the Auto Aspect feature:
Select Off in step 3 above.
Automatic aspect size
(automatically selected
when Auto Aspect is On)
Natural (with side bars)
TheaterWide 2
Full
User-selected picture size
(see pages 61–62)
Exit
TheaterWide 3
Film
On
Done
63