Connecting A Vcr And Satellite Receiver - Toshiba 32HL95 Owner's Manual

Connecting a VCR and satellite receiver

Note: The TV Guide On Screen™ system does not receive program
listings from or for any satellite service.
You will need:
one signal splitter
three coaxial cables
one set of component video cables (if your
satellite receiver does not have component
video, connect the standard A/V cables only)
one pair of standard audio cables
three sets of standard A/V cables
• For better picture performance, if your satellite receiver and VCR
have S-video, connect S-video cables (plus the audio cables)
instead of the standard video cables. Do not connect both types of
video cable to VIDEO 1 at the same time or the picture
performance will be unacceptable.
• If you have a mono VCR, connect L/MONO on the TV (VIDEO 1) to
your VCR's AUDIO OUT terminal using the white audio cable only.
To view satellite programs using the component video
connections:
Select the ColorStream HD-1 video input source on the TV.*
To view satellite programs using the standard
video connections or to record satellite programs:
Turn on all three devices. Set the VCR to the appropriate
line input (refer to your VCR owner's manual for details).
Select the VIDEO 2 video input source on the TV.*
To view the VCR or view and record antenna channels:
Turn ON the VCR. Tune the VCR to the channel you want to
watch. Select the VIDEO 1 video input source on the TV.*
_____________
*
To select the video input source, press INPUT on the remote control
(see page 56). To program the TV remote control to operate other
devices, see Chapter 3.
To enable the TV Guide On Screen™ system to work
with your cable box and to use the TV Guide
On Screen™ recording features:
1. Connect the G-LINK™ cable according to the
instructions on page 21.
2. Make sure the VCR is connected to the A/V OUT
terminals on the TV (see illustration).
3. Set the VCR to the appropriate line input (refer to your VCR
owner's manual for details), and then turn OFF the VCR.
4. See Chapter 5 for details on setting up the TV Guide
On Screen™ system.
5. See Chapter 7 for details on using the TV Guide
On Screen™ system.
Chapter 2: Connecting your TV
From satellite dish
Satellite
Satellite receiver
Note: The VIDEO/AUDIO OUT terminals output signals from the
ANT 1, ANT 2, VIDEO 1, and VIDEO 2 terminals when the
appropriate input mode is selected.
The unauthorized recording, use, distribution, or revision of television
programs, videotapes, DVDs, and other materials is prohibited under the
Copyright Laws of the United States and other countries, and may subject
you to civil and criminal liability.
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
From antenna
IN
Signal splitter
OUT OUT
VIDEO
CH 3
CH 4
TV lower back
panel
Y
P P
B R
IN
S-VIDEO COMPONENT VIDEO VIDEO
OUT OUT
Stereo VCR
AUDIO
L R
IN from ANT
IN
OUT to TV
OUT
L R
TV upper back panel
AUDIO
OUT
L L
R R
15