Table of Contents
Advertisement
Available languages
Available languages
IMPORTANT NOTES
Power Supply
301
•
Do not connect this unit to same electrical outlet that is being
used by an electrical appliance that is controlled by an inverter
(such as a refrigerator, washing machine, microwave oven, or air
conditioner), or that contains a motor. Depending on the way in
which the electrical appliance is used, power supply noise may
cause this unit to malfunction or may produce audible noise. If it
is not practical to use a separate electrical outlet, connect
a power supply noise filter between this unit and the electrical
outlet.
307
•
Before connecting this unit to other devices, turn off the power
to all units. This will help prevent malfunctions and/or damage to
speakers or other devices.
308
•
Although the LEDs are switched off when the POWER switch is
switched off, this does not mean that the unit has been
completely disconnected from the source of power. If you need
to turn off the power completely, first turn off the POWER switch,
then unplug the power cord from the power outlet. For this
reason, the outlet into which you choose to connect the power
cord's plug should be one that is within easy reach and readily
accessible.
Placement
351
•
Using the unit near power amplifiers (or other equipment
containing large power transformers) may induce hum. To
alleviate the problem, change the orientation of this unit; or
move it farther away from the source of interference.
352a
•
This device may interfere with radio and television reception. Do
not use this device in the vicinity of such receivers.
352b
•
Noise may be produced if wireless communications devices, such
as cell phones, are operated in the vicinity of this unit. Such noise
could occur when receiving or initiating a call, or while
conversing. Should you experience such problems, you should
relocate such wireless devices so they are at a greater distance
from this unit, or switch them off.
354b
•
Do not expose the unit to direct sunlight, place it near devices
that radiate heat, leave it inside an enclosed vehicle, or otherwise
subject it to temperature extremes. Also, do not allow lighting
devices that normally are used while their light source is very
close to the unit (such as a piano light), or powerful spotlights to
shine upon the same area of the unit for extended periods of
time. Excessive heat can deform or discolor the unit.
355b
•
When moved from one location to another where the
temperature and/or humidity is very different, water droplets
(condensation) may form inside the unit. Damage or malfunction
may result if you attempt to use the unit in this condition.
Therefore, before using the unit, you must allow it to stand for
several hours, until the condensation has completely
evaporated.
356
•
Do not allow rubber, vinyl, or similar materials to remain on the
unit for long periods of time. Such objects can discolor or
otherwise harmfully affect the finish.
359
•
Do not paste stickers, decals, or the like to this instrument.
Peeling such matter off the instrument may damage the exterior
finish.
4
360
•
Depending on the material and temperature of the surface on
which you place the unit, its rubber feet may discolor or mar the
surface.
You can place a piece of felt or cloth under the rubber feet to
prevent this from happening. If you do so, please make sure that
the unit will not slip or move accidentally.
Maintenance
401a
•
For everyday cleaning wipe the unit with a soft, dry cloth or one
that has been slightly dampened with water. To remove
stubborn dirt, use a cloth impregnated with a mild, non-abrasive
detergent. Afterwards, be sure to wipe the unit thoroughly with
a soft, dry cloth.
402
•
Never use benzine, thinners, alcohol or solvents of any kind,
to avoid the possibility of discoloration and/or deformation.
452Kai
•
Please be aware that unit settings or the contents of the solo
function stored in memory may be lost when the unit is sent for
servicing. Important data should always be written down on
paper. Roland assumes no liability with respect to recovery of
any lost data.
Additional Precautions
551Kai
•
Please be aware that unit settings or the contents of the solo
function stored in memory can be irretrievably lost as a result of
a malfunction or the improper operation of the unit. To protect
yourself against the risk of losing important data, we recommend
that you periodically write down on paper any important data
you have stored in the unit's memory.
552Kai
•
Roland Corporation assumes no liability with respect to recovery
of any lost unit settings or contents of the solo function stored in
memory.
553
•
Use a reasonable amount of care when using the unit's buttons,
sliders, or other controls; and when using its jacks and
connectors. Rough handling can lead to malfunctions.
556
•
When connecting / disconnecting all cables, grasp the connector
itself—never pull on the cable. This way you will avoid causing
shorts, or damage to the cable's internal elements.
557
•
A small amount of heat will radiate from the unit during normal
operation.
558a
•
To avoid disturbing your neighbors, try to keep the unit's volume
at reasonable levels. You may prefer to use headphones, so you
do not need to be concerned about those around you (especially
when it is late at night).
559a
•
When you need to transport the unit, package it in the box
(including padding) that it came in, if possible. Otherwise, you
will need to use equivalent packaging materials.
562
•
Some connection cables contain resistors. Do not use cables that
incorporate resistors for connecting to this unit. The use of such
cables can cause the sound level to be extremely low, or
impossible to hear. For information on cable specifications,
contact the manufacturer of the cable.
Add
•
Do not insert hands, fingers, etc, into the openings in the unit's
rear panel. In particular, if the unit is to used in households with
small children, always provide adult supervision to ensure that
children keep their hands and feet out of these openings.
Advertisement
Chapters
Table of Contents
