Olympus DS-30 Instructions Manual page 37

Troubleshooting
Symptom
Nothing appears
on the display
Won't start
Unable to record
No playback tone
heard
Unable to erase
Noise heard during
playback
Recording level
too low
Unable to set index
marks,
tempmarks
Probable cause
The batteries are not loaded properly.
The batteries are dead.
The power is off.
The power is off.
The recorder is in HOLD mode.
The batteries are dead.
Low remaining internal memory.
The maximum number of files has
been reached.
The earphone is connected.
The VOLUME button is set to O.
The file is locked.
The file is read-only.
The recorder was shaken during
recording.
The recorder was placed near a cell
phone or fluorescent lamp while
recording or during playback.
The microphone sensitivity is too low.
The maximum number of marks has
been reached.
The file is locked.
The file is read-only.
Action
Verify polarity is correct.
Replace with new batteries (1lF P.7).
Check another folder.
Unplug the earphones to use the
internal speaker.
Adjust the VOLUME button (.r P.19).
Unlock the file.
Cancel the read-only setting of the file
on the PC.
Move the recorder.
Unlock the file.
Cancel the read-only setting of the file
on the PC.
37