Table of Contents
Advertisement
Matchmarks
REAR AXLE AND SUSPENSION - Rear Drive Shaft
RA-19
B44B9
C8200
C8124 84492
C8125
DISASSEMBLY OF REAR DRIVE SHAFT
(See page RA-14)
{4A-GE)
1.
CHECK DRIVE SHAFT
2.
3.
(a)
Check to see that there is no play in the inboard and
outboard joint.
(b)
Check to see that the inboard joint slides smoothly in
the thrust direction.
(c)
Check to see that there is no play in the radial direc-
tion of the inboard joint.
(d)
Check for damage to boot.
REMOVE BOOT CLAMPS
DISASSEMBLE INBOARD JOINT TULIP
(a)
Place matchmarks on the inboard joint tulip and
tripod.
CAUTION:
Do not punch the marks.
(b)
Remove the inboard joint tulip from the drive shaft.
4.
DISASSEMBLE TRIPOD JOINT
(a)
Using snap ring pliers, remove the snap ring.
(b)
Using a punch, place matchmarks on the shaft and
tripod.
(c)
Using a hammer and brass bar, drive out the tripod
joint from the drive shaft.
Advertisement
Table of Contents
Troubleshooting
