Unit Installation; Tools Required - ADTRAN Total Access 908e Hardware Installation Manual

Total Access 900e Series Hardware Installation Guide
3.

UNIT INSTALLATION

The instructions and guidelines provided in this section cover hardware installation topics such as wall
mounting, rack mounting, and installing the unit. Refer to Unpack and Inspect the System on page 20
before getting started. The instructions are presented as follows:
• Tools Required on page 21
• Mounting Options on page 22
• Grounding Instructions on page 23
• Supplying Power to the Unit on page 24
For information on configuring a specific application, refer to the quick configuration documents provided
on your ADTRAN OS System Documentation CD.
To prevent electrical shock, do not install equipment in a wet location or during an
electrical storm.

Tools Required

The following customer-provided tools are required for installation of the Total Access 900e Series
hardware:
• Two wood screws, 3/32-inch to 1/8-inch (1 1/2-inches length)
• Drill and drill bit set
• Screwdriver (medium)
• 25-pair male amphenol cable (customer connection)
• Selected punch-down block and tool
To access the command line interface (CLI) of the Total Access 900e Series, you must have
a VT100 terminal or PC with terminal emulation software and a
Instructions on how to access the CLI are given in the AOS Command Reference Guide
(provided on the ADTRAN OS System Documentation CD).
To access the Web-based GUI of the Total Access 900e Series, you must have a PC
connected to an IP network. Instructions on how to access the Web-based GUI are given in
the Web GUI Configuration Guide, document number 61210916L1-42.1 and on the Quick
Start Guide, document number 61210916L1-13 (provided on the ADTRAN OS System
Documentation CD).
64240916L1-34D Copyright © 2006 ADTRAN, Inc.
Unit Installation
port cable.
CRAFT
21