Table of Contents
Advertisement
Installation
1. Connect a LAN port on the SmartRG gateway to the network card of your PC using an Ethernet cable.
2. To connect a broadband device:
Connect one end of an Ethernet cable to the WAN port on the SmartRG gateway and connect the other
l
end of the cable to the broadband device.
Connect one end of the cable supplied by your provider to the broadband modem and connect the other
l
end of the cable to the wall jack installed by your provider.
3. Plug the power adapter to the wall outlet and then connect the other end of it to the Power port of the
gateway.
4. Turn on the unit by pressing the On/Off button on the side of the gateway.
Your gateway is now automatically being set up to connect to the Internet. This process may take a few minutes to
complete before you can begin using your Internet applications (browser, email, etc.).
If you are unable to connect to the Internet, confirm that all cable connections are in place and the gateway's power is
turned on.
Advertisement
Table of Contents
