Introduction; Features And Specifications - ADTRAN Total Access 908e Hardware Installation Manual

Total access 900e series
Hide thumbs Also See for Total Access 908e:
Table of Contents

Advertisement

1.

INTRODUCTION

The Total Access 900e Series products are Integrated Access Devices (IAD) designed for cost-effective
deployment of up to 6 Mbps of data or 48 channels of Voice over IP (VoIP) services. The Total Access
900e Series combines voice and data services into a single platform creating the fourth generation of
ADTRAN IADs for Internet Protocol (IP) telephony service providers (such as CLECs, ILECs, and ISPs).
Total Access 900e Series products are built on the ADTRAN Operating System (AOS) platform and
include the AOS built-in IP router and firewall features. The units include 4 DS1 network interfaces
(
through
), a
interface (up to 24 FXS ports or 16 FXS plus 8 FXO
NET 1, T1 0/1
NET 4, T1 0/4
VOICE
ports), 2 10/100BaseT interfaces (
,
), a single FXO trunk (
), and a
port
ETH 0/1
ETH 0/2
FXO 0/0
CRAFT
(management interface). An optional battery backup is also available for the Total Access 900e Series. The
last two digits of the product name indicate the number of on-board FXS ports. The Total Access 908e
contains 8 FXS ports, the Total Access 916e contains 16 FXS ports, and the Total Access 924e contains 24
FXS ports or 16 FXS ports plus 8 FXO ports with octal FXO daughter board. The units can provision, test,
and provide status for any of the voice and data interfaces. All connections are made via the rear panel.
In common packet-based applications, the WAN (
through
) connects to the
NET 1, T1 0/1
NET 4, T1 0/4
ISP or carrier's network and transmits packetized voice and data over a SIP trunk(s). The customer's voice
is presented as TDM to the FXS ports or PRI/CAS to the remaining DS1 interfaces (
and
NET 3, T1 0/3
), and the data is routed out the LAN (
and
).
NET 4, T1 0/4
ETH 0/1
ETH 0/2

Features and Specifications

The Total Access 900e Series products have the following features:
• Support for 4 DS1 (or 3 DS1 plus 1 PRI/CAS, or 2 DS1 plus 2 PRI/CAS) interfaces
• Support for a single built-in FXO interface
• Support for up to 24 FXS ports with octal FXS daughter board
• Support for up to 16 FXS ports and 8 FXO ports with octal FXO daughter board (Total Access 924e only)
• Supports Primary Rate ISDN (PRI) or Robbed Bit Signaling (RBS) on the PRI/CAS interfaces
• Support for a two auto MDI/MDX 10/100BaseT Ethernet ports (RJ-48C)
• Full-featured AOS IP router/firewall
• QoS/NAT/DHCP client, server, and relay
• Support for SIP trunks
• Support for up to 6 Mbps of multi-link Frame Relay, multi-link PPP
• Support for optional VPN - 500 IPSec tunnels using DES/3DES/AES encryption
• Support for 3-way conferencing
• Support for caller ID, message waiting, and stutter dial tone
• Fax and analog modem compatible (V.90)
• Support for local station to station calls
• Up to 48 channels of G.711 (
µ
-law)
• Up to 48 channels on G.726 (32K ADPCM)
• Up to 48 channels on G.729
• Up to 48 channels of DTMF detection/generation
64240916L1-34D
Copyright © 2006 ADTRAN, Inc.
15

Advertisement

Table of Contents
loading

This manual is also suitable for:

Total access 916eTotal access 924e

Table of Contents