Table of Contents
Advertisement
Installation
1. Connect one end of the included phone cable to the DSL port on the gateway and connect the other end to the
wall jack.
2. Connect one end of an Ethernet cable to a LAN port of the gateway and connect the other end to your PC.
3. Plug the power adapter into the wall outlet and connect the other end of it to the Power port of the gateway.
4. Turn on the unit by pressing the On/Off button on the left side of the gateway.
Your gateway is now automatically being set up to connect to the Internet. This process may take a few minutes to
complete before you can begin using your Internet applications (browser, email, etc.).
Notes:
If you use 3G WAN service, connect the 3G USB data card to the USB port of the gateway. If you use the Ethernet
l
uplink, connect to the WAN port with an Ethernet cable.
You cannot use the xDSL uplink, 3G WAN service, and Ethernet uplink at the same time.
l
If you are unable to connect to the Internet, confirm that all connections are in place and the gateway is turned on.
Advertisement
Table of Contents
