Maintenance - Ryobi RBV26B User Manual

Deutsch (Übersetzung der originalen Anleitungen)
To start the engine:
Follow the instructions on the machine or described earlier
in this manual.
To stop the engine:
BLOWER OPERATION
See Figure 8 - 9.
WARNING:
Do not place blower on top of or near loose
debris or gravel. Debris may be sucked into the
blower intake vent resulting in possible damage
Operate the equipment at reasonable hours only - not
early in the morning or late at night when others might
be disturbed. Comply with the times listed in local ordi-
nances.
used at any one time and operate the blower at the
vibration level.
Check your equipment before operation, especially
the silencer, air intakes and air filters.
Use rakes and brooms to loosen debris before blowing.
In dusty conditions, slightly dampen surfaces.
Watch out for children, pets, open windows, or freshly
washed cars, and blow debris safely away.
Hold blower as shown in Figure 8, so the air stream
can work close to the ground.
Blow around the outer edges of a debris pile to prevent
center of a pile.
After using blowers or other equipment, clean up.
Dispose of debris properly.
NOTE:
for wet sticky leaves. It allows you to scrape wet leaves or
debris while operating the blower.
CRUISE CONTROL
See Figure 10.
without holding the throttle trigger.
lever back towards user and stop at the desired
throttle setting.
lever all the way towards the front of unit.
English (Original instructions)
VACUUM OPERATION
See Figure 11.

MAINTENANCE

17 17
WARNING:
to do so could result in possible serious personal
Install the vacuum tubes and the bag. Refer to the "As-
sembly" section earlier in this manual.
Start the engine. Refer to the "Starting and Stopping"
earlier in this manual.
Place the vacuum bag strap over your right shoulder.
Hold the upper handle in your left hand and the
vacuum handle in your right hand.
Move the equipment from side to side along outer
vacuum tube directly into the debris pile.
Hold the engine higher than the inlet of the vacuum
tube.
Always point the vacuum tube downhill when working
on a hillside.
the unit, do not attempt to suck rocks, broken glass,
If the vacuum tubes get clogged, stop the engine,
ensure the impeller blades have stopped spinning and
disconnect the spark plug wire before cleaning out the
obstruction. Remove the vacuum tubes and clear the
bag and clear the tube. A small rod or stick may be
required to clear the entire tube length. Ensure that
all debris has been cleared before reassembling the
vacuum tubes.
WARNING:
When servicing, use only identical replacement
parts. Use of any other parts may create a
hazard or cause product damage.
WARNING:
Always wear eye protection with side shields
hearing protection. Failure to do so could result
WARNING:
Before inspecting, cleaning, or servicing the
machine, shut off the engine, wait for all moving
parts to stop, disconnect the spark plug wire
and move it away from the spark plug. Failure