Maintenance - Ryobi P2808 Operator's Manual

WARNING:
To avoid serious personal injury, always remove the bat-
tery pack from the tool when cleaning or performing any

maintenance.

WARNING:
Always wear eye protection with side shields or goggles
marked to comply with ANSI Z87.1. Failure to do so could
result in fluids entering your eyes resulting in possible
serious injury.
WARNING:
When servicing, use only identical replacement parts.
Use of any other parts may create a hazard or cause
product damage.
NOTICE:
Periodically inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps,
etc. Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts
are replaced. Please contact customer service or an
authorized service center for assistance.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and may be damaged by their use. Use
clean cloths to remove dirt, dust, oil, grease, etc.
WARNING:
Do not at any time let brake fluids, gasoline, penetrating
oils, etc., come in contact with plastic parts. Chemicals
can damage, weaken, or destroy plastic which may result
in serious personal injury.
MAINTENANCE
CLEANING THE UNIT
See Figure 12.
Always store and dispose of chemicals properly. Disposal
of contaminated rinse water should be performed accord-
ing to local ordinances and bylaws.
Draining the tank:
If there is any liquid left in the tank after spraying, the tank
should be drained before cleaning.
 Turn off the electrostatic function and remove the battery
 Disconnect the hose and sprayer from the tank and
 Drain the contents of the tank through the fill area.
Cleaning the sprayer, tank and spray lines:
 Move the sprayer away from the tank when filling.
 Fill the tank about one-third full with clean water. A small
 Review chemical SDS sheet how best to secure and store
 Replace the tank cap and tighten securely.
 Reconnect the tank and latch to secure.
 Reinstall the battery pack. Spray until the tank has been
 Refill and repeat the procedure with clean water. It may
 Allow all pieces to completely dry before reinstalling parts
 Wipe the outside of the sprayer with a clean, dry cloth.
Cleaning the filter:
 Unscrew the quick connect collar from the tank.
 Remove the filter and flush out debris with clean water.
11 — English
WARNING:
from the unit.
unscrew the cap of the tank.
NOTE: Drain the contents back into the original container.
Do not store chemicals in the tank.
amount of mild household detergent may be added.
NOTE: Never use flammable chemicals or abrasive
cleaning agents to clean the tank.
your chemical solution when not in use.
emptied. Make sure to direct the spray toward an area
that will not be damaged by the spray solution.
be necessary to rinse the tank more than once, then drain
again as directed above.
and storing the unit. Reinstall the tank cap.
NOTE: Store the sprayer in an upright position. DO NOT
store the sprayer on its side.